AUTOUTLET 10PCS 4-pin RGB LED Light Strip Connector LED Strip Wire Connect for 10mm 5050 RGB Waterproof LED Strip

Description

How to connect： Wire End Connection: 1.Cut the desired wire length and insert it directly into the guide slot. 2.Make sure that the positive & negative on the strip light surface are corresponding to the ones on the wires. 3.Close the transparent cap with a plier until it is fully seated on both sides of the bottom base. 4. End of installation. Strip End Connection: 1.Open the transparent cover of connector up to 90 degrees. 2.Peel off the 3M glue from the back of the strip light. 3.Insert the strip section to the end of strip side of connector, keep the PU surface face up. 4.Close the transparent cap with a plier until it is fully seated on both sides of the bottom base. Package content: 10 × RGB/Single LED Connector