sb components Case for Raspberry Pi Model A+ (Plus) Colour: Clear Transparent Access to All Ports

Works well Pi 3 A+. The fit very good. I am pleased with the product.

I like the RPi A+ size case to use for holding HAT modules that are connected back to the RPi with a 40 wire ribbon cable GPIO extender. But i am willing to hack the case if i need to for extra port access on the HAT. So it is good that the case is easy to cut or drill.Just what i wanted.

Great price and fits perfectly. Didn't have any issues inserting a micro SD like another reviewer mentioned. Also no issues inserting HDMI, micro USB, or USB with the case on. Would definitely purchase again!

Best case I've found. I've got an A+, a B, a B+, a 2B and a BananaPi all in SB Components cases. They fit perfectly. I've not had good luck with any of the others I've tried.

This unit works OK. A Raspberry Pi A+ snaps in pretty easily with a snug fit. The ports in the plastic allow access to various Pi connectors. The quality of the plastic is fine for the price. Unfortunately this case is too short to accommodate most Raspberry Pi hats and still close the lid, so just plan on running the Pi with cabled connectors, no hats.

No screws or instructions.

This is a great little case for the A+. It is very sturdy and fits the Raspberry Pi perfectly. My only real complaint is that I wish it had a snap-on cover for the I/O pins since they are a little exposed.

Case would only fit PI and close when SD card was removed, as it is just long enough to place the board itself in. Could not put a cardless PI in and then insert the card because the 'access' port in the case is too low; The SD card slot is blocked. Even when closed, the case did not snap completely; Lid was uneven. Disappointed.