MAS Door Jam Wire Boot Small 5'' Long x3/8'' Inside Diameter

Installed. Some speakers in a door that had no door speaker from the factory. These worked perfectly and made it look so dang professional. I am extremely pleased with these wire loom boots. Easy to install. Flexible and yet very strong rubber construction.

Perfect for what I needed

Needed for installation of door speakers in an old truck. These are a shorter version, and are only large enough for 1 pair of speaker wire. They worked perfectly for my application.

The speaker wires in my 1964 Tempest were getting pinched in the door jambs. Theses wire boots were easy to install and have solved the problem.

I measured it and it was short it was actually 4” and the diameter was not correct as well was too short for the application I was wanting to use it for plus it would not fit the wire

I'm not going to use them but they are flexible. The only thing I didn't like is that they kink in the middle. I'll keep them for something else.

Here are the measurements since there has been more than one person asking. The 'grommet ends' are 1/2", but I suspect you'd want to make the holes 7/16" to make sure it stays in place. The ID is 3/8" which would be enough for one speaker's wires and perhaps wires for either door locks or a courtesy light on the door panel. The length is 5"As near as I can tell this will work for me.

work great